Airflow problems are more common than motor faults.
Start Here
Empty bin or bag.
Clean/replace filters.
Inspect hose for clogs.
Check brush roll.
Look for cracked seals or hoses.
Most unnecessary repairs begin with a real symptom and an unsupported conclusion. Airflow problems are more common than motor faults. For vacuum cleaner has weak suction, concentrate on interlocks, compact mechanics and safe external diagnosis. Use every working function as evidence: if one stage still behaves normally, that fact eliminates causes that would have stopped the appliance earlier in the sequence.
Observe the timing before touching anything. Note what happens immediately after Start, what changes just before the fault, and what remains normal afterward. Lights, relay clicks, water movement, motor or fan sounds, heat, vibration and error codes are useful only when tied to a point in the cycle. A fault that appears instantly is a different problem from one that appears only after the machine warms up or reaches a later stage.
Begin with the cheapest conditions to verify: empty bin or bag, then clean/replace filters. Do not merely glance at them. Compare the actual condition with the manual, correct anything obviously wrong, and retest before moving deeper. Simple installation, maintenance and user-setting problems regularly imitate failed electrical parts.
If those checks pass, move to inspect hose for clogs. Then decide whether check brush roll can be evaluated safely with power isolated. Choose one test that answers one question: blocked or clear, open or closed, free or jammed, intact or electrically open. If a test result would not change your next decision, the test is probably not worth doing.
Avoid washing non-washable filters, running with clogged filters, and probing motor wiring while connected. All three skip evidence and can turn a minor fault into an expensive one. After a correction, reassemble guards and connectors, restore normal settings, and reproduce the original operating conditions. A single successful start is not proof; the original symptom must stay gone through the stage that used to fail.
A Safe Step-by-Step Check
Document the exact symptom and pay special attention to empty bin or bag.
Remove external causes first; specifically verify clean/replace filters.
With power isolated where required, inspect inspect hose for clogs and then evaluate check brush roll only if it can be done safely.
Reassemble fully and run a controlled test under the conditions that previously caused the fault.
Common Beginner Mistakes
Washing non-washable filters.
Running with clogged filters.
Probing motor wiring while connected.
STOP AND GET HELP: If the next useful test requires exposed live mains, defeating a safety interlock, opening a sealed refrigeration circuit, disturbing gas controls, or entering a microwave high-voltage section, the diagnosis has reached the professional-service boundary.