Leveling, load distribution and shipping hardware cause many complaints.
Start Here
Confirm transit bolts were removed.
Level all feet.
Test with a balanced load.
Inspect drum for foreign objects.
Check for excessive bearing play.
Most unnecessary repairs begin with a real symptom and an unsupported conclusion. Leveling, load distribution and shipping hardware cause many complaints. For washer is loud or walks, concentrate on the fill, wash, drain, lock and spin sequence. Use every working function as evidence: if one stage still behaves normally, that fact eliminates causes that would have stopped the appliance earlier in the sequence.
Observe the timing before touching anything. Note what happens immediately after Start, what changes just before the fault, and what remains normal afterward. Lights, relay clicks, water movement, motor or fan sounds, heat, vibration and error codes are useful only when tied to a point in the cycle. A fault that appears instantly is a different problem from one that appears only after the machine warms up or reaches a later stage.
Begin with the cheapest conditions to verify: confirm transit bolts were removed, then level all feet. Do not merely glance at them. Compare the actual condition with the manual, correct anything obviously wrong, and retest before moving deeper. Simple installation, maintenance and user-setting problems regularly imitate failed electrical parts.
If those checks pass, move to test with a balanced load. Then decide whether inspect drum for foreign objects can be evaluated safely with power isolated. Choose one test that answers one question: blocked or clear, open or closed, free or jammed, intact or electrically open. If a test result would not change your next decision, the test is probably not worth doing.
Avoid tightening feet while machine is unstable, ignoring deep rumbling during spin, and assuming every vibration needs new shocks. All three skip evidence and can turn a minor fault into an expensive one. After a correction, reassemble guards and connectors, restore normal settings, and reproduce the original operating conditions. A single successful start is not proof; the original symptom must stay gone through the stage that used to fail.
A Safe Step-by-Step Check
Document the exact symptom and pay special attention to confirm transit bolts were removed.
Remove external causes first; specifically verify level all feet.
With power isolated where required, inspect test with a balanced load and then evaluate inspect drum for foreign objects only if it can be done safely.
Reassemble fully and run a controlled test under the conditions that previously caused the fault.
Common Beginner Mistakes
Tightening feet while machine is unstable.
Ignoring deep rumbling during spin.
Assuming every vibration needs new shocks.
STOP AND GET HELP: If the next useful test requires exposed live mains, defeating a safety interlock, opening a sealed refrigeration circuit, disturbing gas controls, or entering a microwave high-voltage section, the diagnosis has reached the professional-service boundary.